1 · Shadow designrequired
Drop an image or click to chooseAny image. We convert it to SVG for you
2 · Box pictureoptional
Drop an image or click to choosePrinted on the box floor. Leave empty for a plain box.
Figure
Type a size. The box raises its LED and panels by itself to reach it.
Box shape
Box size
3D
Shadow on the wall
Dark = shadow cast by the printed panels. Amber = part of the figure where light leaks. The dark box with the glowing LED is the lamp itself.
Shadow size on wall-
Figure lost above panel top-
Floating detail-
Box outer size-
Estimated weight-
Estimated cost-
Print and build notes
- Print in black or dark PLA/PETG so the panels block light fully. Panels print flat, stencil face up is the inside.
- Stand the panels around the floor rim: top and bottom are the long ones, left and right fit between. Glue the corners and hang by the hole near the top.
- Put a 5 mm warm-white LED in the socket at the top of the tube and wire it down through the floor.
- Print the box picture plate in black and glue it on a light floor.
- Thin struts hold floating pieces and show as thin radial lines in the shadow.